| Line 1 was replaced by lines 1-2 |
| - [{Image src='DIL/dil2Open.jpg' align='right'}] |
| + [{Image src='DIL2/dil2Open.jpg' align='right'}] |
| + [{Image src='DIL2/dil2.jpg' align='right'}] |
| Line 6 was replaced by line 7 |
| - It is equipped with a weak link, allowing access to the |
| + It is equipped with a [weak link|Dil2WeakLink], allowing access to the |
| At line 8 added 4 lines. |
| + [Sample Mounting|DilSampleMounting] |
| + |
| + [DIL1/dilGeometry.gif] |
| + |
| Lines 10-21 were replaced by lines 15-21 |
| - * The weak link is too weak. For the first experiments we |
| - will use a simple copper sample holder, and use the sensor |
| - on the mixing chamber. |
| - |
| - !DIL2 Sample mounting |
| - |used in||MA15||MA11||MA02||MA09 |
| - |sample space diameter [[mm]|17.3|17.3|23.6|45 |
| - |max. sample diameter [[mm]|12|12|18|35 |
| - |distance from thread to beam center [[mm]\\adjustable by about +- 10 mm|40|51|97|194 |
| - |allowed size below beam center [[mm]|64|30|60|24 |
| - On the mixing chamber, there is a bolt with an M5 thread |
| - (on the sample container a 7 mm deep hole with an M5 thread is needed). |
| + * The weak link was too weak, and there was no spacer on it. |
| + We have shortened the weak section and put a spacer above |
| + it. |
| + |
| + * The gauges G1 and G2 do not work reliably. As a workaround, |
| + the (earlier unused) G3 gauge has now a connection to the |
| + beam dump. |
| Removed lines 27-28 |
| - [Temperature Control|ControlTemperatureDIL] |
| - |
| At line 31 added 21 lines. |
| + |
| + !Sensor Calibration |
| + The calibration curve in the FemtoPower system from Oxford Instruments |
| + is generic. For more precise values use the table below. |
| + ||Display||Mix.Ch. |
| + |0.040|0.042 |
| + |0.060|0.063 |
| + |0.080|0.084 |
| + |0.100|0.105 |
| + |0.150|0.156 |
| + |0.200|0.206 |
| + |0.300|0.306 |
| + |0.400|0.404 |
| + |0.600|0.600 |
| + |0.804|0.800 |
| + |1.01 |1.00 |
| + |1.52 |1.50 |
| + |2.03 |2.00 |
| + |3.04 |3.00 |
| + |4.02 |4.00 |
| + |5.00 |5.00 |
LIN