| At line 4 added 4 lines. |
| + For larger samples, the opening angle for full access is sligthly smaller. |
| + In the field direction, the vertical access is +- 22.5, in fact, the access |
| + is a cone. Perpendicular to the field direction, the access is +-6.7 deg on |
| + a 15 mm sample, or 65 mm parallel access. |
| At line 15 added 4 lines. |
| + [MA7 Specifications] |
| + |
| + More information on intranet page (drawing): [LdmWiki:MA7] |
| + |
| At line 19 added 1 line. |
| + [MA7/asysym.jpg] |
| Line 22 was replaced by line 31 |
| - For changing for symmetric mode to asymmetric and vice versa: |
| + For changing from symmetric mode to asymmetric mode and vice versa: |
| Lines 24-25 were replaced by lines 33-52 |
| - * change a cable on the top of the magnet under the aluminium cyclinder |
| - * change the configuration of the IPS, (Test 07): |
| + * on the top of the magnet under the aluminium cyclinder: |
| + ** make sure that the magnetic field is zero (IPS: shown current is 0 AND "persistent mode" LED is off) |
| + ** switch the magnet power supply IPS off |
| + ** open the cap using the screws marked on the picture above |
| + ** switch the cable from the SYM pin to ASY pin (or vice versa) |
| + ** the cable connected to the COM pin must always stay connected |
| + ** close the cap |
| + ** switch the magnet power supply on |
| + * change the configuration of the IPS: |
| + ** press RAISE+LOWER+LOC/REM simultanously ("tESt" and "t 00" appears) |
| + ** press LOWER to go to "t 07", and then LOC/REM (""SUP" and "S 00" appears) |
| + ** press LOWER 5 times to go to "S 11" and then press LOC/REM (the induction value appears) |
| + ** press and hold LOC/REM and change the value with RAISE or LOWER, release LOC/REM when done |
| + ** press RAISE 7 times to go to "S 02" and then press LOC/REM (the value for max. current appears) |
| + ** press and hold LOC/REM and change the value with RAISE or LOWER, release LOC/REM when done |
| + ** press LOWER once to go to "S 01" and then press LOC/REM (the value for max. current appears) |
| + ** press LOC/REM again (the value for max. field appears) |
| + ** press and hold LOC/REM and change the value with RAISE or LOWER, release LOC/REM when done |
| + ** press LOWER once to go to "S 00" and then press LOC/REM ("tESt" and "t 00" appears) |
| + ** press LOC/REM again ("Stor.y" appears) and again |
| At line 27 added 1 line. |
| + |S11 (coil inductance) | 112 | 78.7 |
| Removed line 30 |
| - |S11 (coil inductance) | 112 | 78.7 |
LIN