OmegaMotorChangeOnRita2

Your trail:
Search SINQ Wiki:
SINQ LIN

SINQ Wiki
- Main Page
- Search SINQ Wiki
- Sample Environment
- Probenumg. Intern
- Troubleshooting SICS

This Page
- Page Info
- Printer Friendly

Referenced by
MA15

Wiki Info
- Unused pages
- Undefined pages
- RecentChanges
- Page Index
- System Info
- JSPWiki Docu
- SandBox
- OneMinuteWiki
- Create a New Page




JSPWiki v2.0.52


This is version 3. It is not the current version, and thus it cannot be edited.
[Back to current version]   [Restore this version]

Procedure to Change from/to the Omega Motor on the Sample Stick

Make sure that the serial line (RS232) to the motor controller is connected and that the motor controller is switched on.

In /home/rita2/rita2_sics/rita2.tcl change the following line 

  set ma15motor 1  (1 for motor on sample stick, 0 for normal omega table)
and then restart sics with the command 
  monit restart sicsserver
on the unix prompt.

If the motor is not running, it may be necessary to load the motor parameters with the el734_test program. Type 

  el734_test -help
for documentation. A parameter file can be found under /home/users/tascom/PSI/mot_4_01.par

Actually the serial cable for the omega motor is connected to channel 4 (port 3004) on the terminal server lnsts02.psi.ch.

This particular version was published on 16-Jun-2008 11:35:16 UTC by ChrstofNiedermayer.