MA11Installation

Your trail:
Search SINQ Wiki:
SINQ LIN

SINQ Wiki
- Main Page
- Search SINQ Wiki
- Sample Environment
- Probenumg. Intern
- Troubleshooting SICS

This Page
- Page Info
- Printer Friendly

Referenced by
MA11

Wiki Info
- Unused pages
- Undefined pages
- RecentChanges
- Page Index
- System Info
- JSPWiki Docu
- SandBox
- OneMinuteWiki
- Create a New Page




JSPWiki v2.0.52


This is version 11. It is not the current version, and thus it cannot be edited.
[Back to current version]   [Restore this version]
MA11Installation/ma11_fig1.jpg MA11Installation/ma11_fig2.jpg MA11Installation/ma11_fig3.jpg

Electrical Connections

on cryostat on rack (should not be disconnected)
switch heater, warn light(11) small 6 pin LEMO below warn light switch heater on IPS (45)
fixed connection to warn light power supply
VTI sensors & heater (12) 10 pin fisher on VTI (4a/4b) sensor A/sensor B + heater (42) via relay (43) on LakeShore 340
Magnet power leads (22) magnet power connections on LHe neck(48) magnet power leads on IPS
LHe level (13) small 4 pin (fisher?) on LHe neck (4h) sensor 1 on ILM211
LN2 level (21) large 4 pin (fisher?) on LN2 neck (4n) sensor 2 on ILM211
sample sensors (14) top of sample stick (4c/4d) sensor C/sensor D on LakeShore 340 + heater OUT2 (44)
VTI needle valve motor (not used) leave unconnected ITC503 15 pin DSUB on green platine

Cryogenic Connections

He recovery (16) He neck recovery port (without valve) He recovery
VTI pumping line (17) VTI pumping port
(do not open valve before tube is pumped out) 		(31) VTI pump (top port)
recovery of pumped He (VTI) (32) VTI pump (side port) He recovery
lambda pump (for fields > 10 Tesla)(18) lambda pump port on He neck (31) Lambda pump (top port)
recovery of pumped He (lambda) (32) lambda pump (side port) He recovery

Computer Connections

SANS-I SANS-II AMOR
LakeShore 340
SERIAL-I/O (41) 		port 11
RJ11 in grey adapter + gender changer		port 6 port 10
IPS magnet power supply
RS232 (46) with grey adapter and RJ45		port 12
RJ45 in grey adapter + gender changer		port 7
ILM211
RS232 (40) with grey adapter and RJ45

Tecs Configuration

  • the TecsServer must be running (if not: in the instruments account, type monit start tecs)
  • within a SICS client type tecs on and then tt device ma11
    ma11 may be replaced by ma11r (for the rotatable sample stick) or ma11a (for asgers special sample stick)

Magnet power supply configuration

  • within a SICS client type ips on and then ips help

Attachments:  ma11_fig4.jpg  ma11_fig1.jpg  ma11_fig2.jpg  ma11_fig3.jpg 
This particular version was published on 28-Jul-2005 15:05:08 UTC by MarkusZolliker.