Removed lines 1-4 |
- !!New Common Triple Axis Syntax |
- |
- M. Zolliker, 7 April 2005 |
- |
Lines 7-8 were replaced by lines 3-7 |
- The command name is __DRIVE__, as on other instruments. |
- __DR__ is defined as an alias. |
+ The command name is __DR__. The command __drive__ as used at other instruments is available but behaves |
+ differently. |
+ |
+ [Markus Zolliker]: ''this behaviour may confuse the user. My proposition is to rename |
+ the original sics drive command and to make __dr__ and __drive__ act similar'' |
Line 15 was replaced by line 14 |
- Drive within scattering plane: |
+ Driving Q: |
Lines 21-22 were replaced by line 20 |
- value). It is an error to give less than 3 numbers, or to |
- drive outside the scattering plane. |
+ value). It is an error to give less than 3 numbers. |
Line 24 was replaced by lines 22-23 |
- To drive in 3 dimensions: |
+ WARNING: The new system allows to drive Q out of plane within the limits of the sample goniometers sgu and sgl. If there is some |
+ sample device on the table which may not be tilted, restrict the movements of sgu and sgl through software limits. |
Line 26 was replaced by lines 25-26 |
- {{> DR Q3}} ''qh qk ql en'' |
+ [Markus Zolliker]: ''this behaviour is dangerous, because people will always forget to set software limits. My proposition is to have different names for Q-variables driven in 2 |
+ and 3 dimensions. An error should be signaled when driving the 2D Q-variable out of plane'' |