| Line 45 was replaced by line 45 |
| - !!Sea/SICS COmmands |
| + !!Sea/SICS Commands |
| At line 48 added 3 lines. |
| + * disable the sample heater |
| + {{ts set 0}} |
| + |
| Line 52 was replaced by line 55 |
| - * set the sorb heater to 30 K and adjust the prop parameter for this |
| + * set the sorb heater to 30 K |
| Removed lines 54-56 |
| - {{ts setsorb/prop 500}} |
| - |
| - * wait 15 min then stop heating the sorb |
| At line 57 added 1 line. |
| + * wait 15 min, then disable sorb heating |
| Line 60 was replaced by line 61 |
| - !regulate at temperatures below 4? K |
| + !regulate at temperatures below ~2 K |
| Line 62 was replaced by lines 63-64 |
| - * set the sorb heater loop to regulate the samlow sensor (channel B) |
| + * disable the sample heater |
| + {{ts set 0}} |
| At line 63 added 1 line. |
| + * set the sorb heater loop to regulate the samlow sensor (channel B) |
| Removed line 67 |
| - |
| Lines 70-71 were replaced by line 72 |
| - * when oszillating, you might need to reduce the prop parameter |
| - |
| + * when oszillating, you might need to reduce the prop parameter from the default value 500 to e.g. 100 |
| Line 76 was replaced by line 77 |
| - !regulate a T > 4 K |
| + !regulate in T range 2 K < T < 20 K |
| Removed line 79 |
| - |
| Lines 83-84 were replaced by line 83 |
| - |
| - {{tt setsorb 15}} |
| + {{ts setsorb 15}} |
| At line 89 added 5 lines. |
| + !higher temperatures and warmup (e.g. 80 K) |
| + |
| + {{tt set 80}} |
| + |
| + For a more precise control {{tt set}} might be set to value slightly lower the the desired T, and {{ts set}} to the desired target. |
LIN