| Lines 14-17 were replaced by lines 14-24 |
| - |Command and subcommand|Description |
| - |mf |r|magnetic field |
| - |mf persmode |w|0: do not work in persistent mode, 1: go to persistent mode after a drive |
| - |mf perswitch|r| |
| + |Command and subcommand| |Description |
| + |mf |r|magnetic field |
| + |mf persmode |w|0: do not work in persistent mode, 1: go to persistent mode after a drive |
| + |mf perswitch |r|state of persistent mode switch |
| + |mf maxlimit |r|maximal limit for field |
| + |mf limit |w|soft limit for field (when set the first time after initialization, maxlimit is also set) |
| + |mf ramp |w|ramp rate (the real ramp rate may be limited by the sweep limits defined in the IPS) |
| + |mf current |r|the current in the leads (converted to Tesla) |
| + |mf lastfield |r|value the the field before goings to persistent mode |
| + |mf confirm |c|confirm the persistent field in case the stored value in the driver does not match the value stored in the IPS |
| + |mf targetValue|r|target value |
| Line 19 was replaced by lines 26-29 |
| - Plus standard commands and parameters defined by EaseBasePar, EaseSendPar |
| + r: read-only |
| + w: writeable parameter |
| + |
| + Plus standard commands and parameters defined by EaseBasePar, EaseSendPar, EaseMsgPar |
LIN