At line 18 added 2 lines. |
+ {{{ |
+ Command Syntax Description |
Lines 20-35 were replaced by line 22 |
- |Syntax | |Description |
- |te |r|the sample temperature (pressure on lambda controller) |
- |te sampleChan |w|the channel used for sample (1..3) |
- |te controlChan |w|the channel for control |
- |te dig1 |w|the number of digits after decimal point, channel 1 (must be configured on an ITC-4, is automatic on an ITC-503) |
- |te dig2 |w|dito on channel 2 |
- |te dig3 |w|dito on channel 3 |
- |te t1 |r|temperature of channel 1 |
- |te t2 |r|temperature of channel 2 |
- |te t3 |r|temperature of channel 3 |
- |te htrMode |r|heater mode (0: manual, 1: auto, 2:auto needle valve) |
- |te htr |r|heater output |
- |te gasMode |w|gas mode (0: manual, 1: auto) |
- |te gas |r|needle valve position |
- |te setGas |w|set needle valve position |
- |te autoGasLimit|w|below this temperature, gas is switched to manual mode, using the value given by setGas |
+ te (r) the sample temperature (pressure on lambda controller) |
Line 37 was replaced by lines 24-38 |
- r: read-only, w: writeable parameter |
+ te sampleChan (w) the channel used for sample (1..3) |
+ |
+ te controlChan (w) the channel for control |
+ |
+ te dig1 (w) the number of digits after decimal point |
+ te dig2 (must be configured on an ITC-4, is automatic |
+ te dig3 on an ITC-503) |
+ |
+ te t1 (r) temperature of channel 1 |
+ te t2 (r) temperature of channel 2 |
+ te t3 (r) temperature of channel 3 |
+ |
+ te htrMode (r) heater mode (0: manual, 1: auto, 2:auto needle valve) |
+ |
+ te htr (r) heater output |
At line 38 added 13 lines. |
+ te gasMode (w) gas mode (0: manual, 1: auto) |
+ |
+ te gas (r) needle valve position |
+ |
+ te setGas (w) set needle valve position |
+ |
+ te autoGasLimit (w) when the controlled tempeature goes below this |
+ value, gas is switched to manual mode, using the value |
+ given by setGas. 1 K above this value, gas is |
+ switched to auto mode |
+ |
+ r: read-only, w: writeable parameter |
+ }}} |